Which is a good corrosion-resistant floating submersible mixer

Corrosion resistant floating submersible mixerIt consists of submersible motor, sealing mechanism, impeller, guide cover, hand-operated hoist, electrical control and other parts. The stirring impeller rotates and stirs the liquid under the drive of the motor, generating a rotating jet and using the shear stress along the surface of the jet to mix. The liquid outside the flow field is stirred by friction, forming a volumetric flow while mixing. The large volume flow mode is applied to control the transportation of the fluid. The equipment adopts large displacement, propeller type propulsion impellers and blades as the main hydraulic components. During operation, the submersible motor drives the propulsion impellers and blades to work, generating a certain flow velocity and field of fluid, forming a circular main flow belt towards the bottom and surroundings of the pool. Due to the high flow velocity of the main stream, a turbulent area centered around it is formed, which promotes the formation of a large circulation of up and down flipping in the entire water body, thereby achieving large-scale three-dimensional circulation agitation, keeping the sludge in the tank in a constantly flipping and suspended state, achieving the goal of uniform and gentle agitation, and improving the treatment effect.

Corrosion resistant floating submersible mixerInstallation and debugging

1. Tighten the four float hoops to the middle positions of the four sides of the float box, and then connect one end of the fixed steel wire rope to the earring on the hoops with a shackle. During installation, four sufficiently long and sturdy ropes should be prepared according to the site conditions, and the other end of the steel wire rope should be securely fastened.

2. The cable of the submersible mixer should be fixed on a steel wire rope and extended to the shore to connect to the electrical control cabinet.

3. Check the rotation direction of the motor. Before the initial installation and start-up of the submersible mixer, or after each reinstallation, the rotation direction should be checked. The inspection method is to instantly start the submersible mixer and observe the rotation direction of the impeller and the direction indicated on the label. If the rotation direction is not *, simply exchange the positions of any two phase lines in the three phases. If multiple submersible mixers are connected to the same control box or terminal, each submersible mixer must be inspected separately.

4. Secure the float with a lifting device and pay attention to balance. Do not hang it directly on the hoop earrings. Use lifting equipment to slowly lift the entire machine and slowly place it into the pool water

In the middle, untie the lifting device and gently pull it to the position in the pool with a fly rope. Place the float in a diamond shape with four corners facing the edges of the pool. Then slightly tighten the steel wire rope and visually observe that the two steel wire ropes on the opposite side are in a straight line. The two straight lines formed by the four steel wire ropes intersect vertically and are perpendicular to the four sides of the float. Drill a hole in a sturdy position at the top of the pool wall along the direction of the steel wire rope, fix the ground pile with expansion bolts, adjust the length of the four steel wire ropes, pay attention to the possible drop in water level, release enough allowance, clamp the clamp, and fix it to the ground pile with a shackle. During the entire lifting process, always pay attention to protecting the cables and never allow the use of submersible mixer cables to lift or suspend the mixer.