Comb tooth magnetic separator manufacturer

For machine tool cutting and chip cutting fluid processing, magnetic separators are ideal tools, and magnetic separators are often used as effective pre-treatment equipment for filters.

The comb shaped magnetic separator provided by Yantai Yunfan Filtration System Company adopts a worm gear reducer or gear reduction motor for the transmission part. The magnetic field strength on the surface of the magnetic cylinder is high, which is particularly suitable for the adsorption and separation of weak magnetic chips. Compared with ordinary rubber roller type magnetic separators, the surface overcurrent and adsorption area are increased.

It is more suitable to separate chips into granular form, such as steel chips processed by deep hole drilling.

The conventional processing capacity of a single machine is100L/min--1000 L/min.100-500 liters per minute processing capacity comb magnetic separatorMore common.

If the horizontal upward scraper plate at the slag outlet of the separator is too long, it is easy for the chips to accumulate for too long and not fall off, resulting in plate formation. If it is too short, the chip water control time will be shorter and there will be more water carried. The specific length will be determined based on the on-site situation.

Due to the comb like design of the working surface of the magnetic cylinder, the flow rate of the liquid is increased and the adsorption area is also increased. The work efficiency is improved, and ferrite or neodymium iron boron permanent magnet materials are used inside the magnetic cylinder to generate a strong magnetic field. The slag scraper plate at the slag discharge port is made of stainless steel material, which is wear-resistant and stable. The installation angle of the scraper is slightly inclined upwards when viewed from the side of the magnetic separator to prevent coolant from flowing into the slag collection box and causing waste.

The chip collecting plate is generally inclined downwards, but can also be designed to tilt upwards according to customer requirements (requiring manual cleaning of debris on the chip collecting plate at regular intervals), which can also prevent coolant from flowing into the slag collection box and causing waste.

The grinding chip separation system matched with the rolling mill has a large processing capacity, such as a water pump flow rate generally greater than300For every minute of increase, a water receiving groove is usually added at the inlet of the magnetic separator. This water receiving groove can reduce the flow rate of the incoming water from the machine tool, allowing the incoming water to enter the magnetic separator with a wider drainage basin. This comb tooth magnetic separator with an increased water receiving groove improves the separation effect of abrasives. The comb shaped magnetic separator for adding water receiving channels can be customized according to requirements.

100-500 liters per minute processing capacity comb magnetic separatorCan be designed according to requirements