Wholesale of chain plate chip conveyor

Customized waste chain plate conveyor

oneStructural composition
This series of devices mainly consists of gear reducers, chain plates, chip conveyor housings, cooling boxes, etc. According to different requirements, water tanks, cooling pumps, vortex separators, electrical control boxes, chip collection vehicles, etc. can also be configured.
2、 Appearance features
The chip conveyor adopts a closed structure and can be placed in an oil tank or coolant tank to separate chips and purify cutting fluid.
3、 Instructions for use
1. When the machine tool starts working, the chip conveyor must work simultaneously. Do not start it when there is too much chip accumulation to avoid malfunctions or jamming.
2. The chip conveyor should not be parked for too long. If it is not used continuously for more than a month, the chip conveyor should be started and allowed to rotate for one hour without load to prevent rusting of the connecting shafts inside the machine, which may cause dead joints in the chain plate.
4、 Easy maintenance
1. If the overloaded sprocket slips, stop immediately and check the cause of the jam.
2. This equipment is equipped with an electrical overload protection device. If a trip occurs, the above operation can be followed to handle it, and then the overload protection button in the electrical box can be pressed to continue working.
3. If the chip conveyor still cannot work normally after the above maintenance, the manufacturer should be contacted immediately for handling. Operators are strictly prohibited from dismantling the chip conveyor and electrical box for self maintenance.
5、 Daily maintenance
1. The tightness of the chip conveyor chain has been adjusted before leaving the factory. After a period of use, the chain plate (strip) will stretch. At the head of the chip conveyor, adjust the bolts and move the main drive shaft forward until the tightness is appropriate.
2. Bearings, chains, and reducers should be inspected and lubricated every three months.
3. Clean up the accumulated debris in a timely manner to prevent excessive accumulation and blockage.
4. The chip conveyor has been parked for too long and needs to be lubricated with oil during use.

Customized waste chain plate conveyor

sixInstallation
During installation and use, the chip conveyor must not be skewed on both sides, and its inclination should not exceed 5 ° -10 °.
8、 Precautions
1. When the chip conveyor is working, it is not allowed to reverse the chip conveyor, and it is forbidden to insert hands into the machine body or gear parts to prevent injury.
2. It is strictly prohibited to stand on the scraper or place heavy objects.
3. Prevent the workpiece from falling onto the chain plate and damaging the scraper.
4. Timely clean the chip collection vehicle to prevent iron chips from being brought back into the chip conveyor by the chain plate, causing jamming.
5. It is strictly prohibited to dismantle the chip conveyor and electrical control device without authorization.
6. Ensure that the chip conveyor runs synchronously with the machine tool.