Which is a good gas generator

NegotiableUpdate on 05/11

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

After purchasing the 30 kW three-phase four wire gas generator HS30REG machine, add the appropriate amount of gasoline and engine oil. The gasoline is unleaded gasoline above 90 #, and the engine oil is suitable for ordinary cars. The fuel is very easy to buy; Then simply turn on the switch (the generator is started by electricity, just like starting a car, it can be turned on with just one key), and then insert the necessary equipment into the power interface on the surface of the generator to use it! It is recommended to read the user manual before use. The manual provides detailed instructions on how to use the machine and how to maintain and protect it. It is also for safe use!

Product Details

30 kW three-phase four wire gas generator HS30REG

After starting the diesel generator, it will continue to operate continuously. However, sometimes there may be a problem where the generator runs weakly after starting, which not only affects its use but also causes damage to the diesel generator. So, what is the reason for this phenomenon? How should we solve it? Below, the Starlight diesel generator manufacturer will explain to you the malfunction of the diesel generator set's inability to start and operate:

When the diesel generator is started, the crankshaft rotates intermittently or rotates slowly, which prevents the diesel engine from entering a self operated state. This type of malfunction should not be caused by insufficient battery power, excessive starting resistance, or poor contact surface after burning of the movable and stationary contacts inside the electromagnetic switch. The inspection method is as follows.
1. Check if the battery is fully charged.
2. Check the contact between the electric brush and the commutator (or commutator). Under normal circumstances, the contact surface between the bottom surface of the diesel generator brush and the commutator should be at least 85%. If it does not meet the technical requirements, a new electric brush should be replaced.
3. Check if the commutator (commutator) has any signs of burning, wear, scratches, dents, etc. If there is a lot of dirt on the surface of the rectifier, clean it with diesel or gasoline. If there is severe burning, scratching, and wear, causing the surface to be uneven or out of roundness, repair or replacement may be necessary depending on the situation. When repairing, the rectifier can be machined with a lathe and polished with a fine sandpaper.
4. Check the working surfaces of the movable contacts and two stationary contacts inside the electromagnetic switch of the generator. If the movable contacts and stationary contacts are burnt and cause the starter to run weakly, they can be ground flat with a fine sandcloth.