Price for the trial mold of a cylinder with a diameter of 160 * 320

Elastic modulus cast iron cylindrical test mold

Elastic modulus cast iron cylindrical test moldWidely used in highway engineering construction testing, railway engineering construction testing, construction site engineering construction testing, commercial concrete mixing plant testing, construction engineering quality supervision testing, as well as the formation of test blocks for concrete flexural testing in various colleges, research institutions, water conservancy engineering, and other fields.

Elastic modulus cast iron cylindrical test moldWhen using, apply engine oil to the inner wall first, and remove the mold within 24 or 48 hours.

Elastic modulus cast iron cylindrical test moldTechnical Specifications：

1. Trial mold size:Φ150×300mm

2. Material: Metal

Elastic modulus cast iron cylindrical test moldOperation Method:

Before placing the test piece, apply lubricating oil or machine oil to the inner wall of the test mold several times. After multiple lubrication cycles, place the test piece and gently stir. After the event solidifies, remove the test mold. When disassembling, loosen the butterfly nut on the joint bolt. Once the butterfly nut on the shaft is loosened and the joint bolt is detached from the side template groove, the side template can be removed. After using the trial mold, it needs to be washed clean with water and coated with a layer of oil on the surface to prevent rusting.

Elastic modulus cast iron cylindrical test moldNotes:

1. When installing the mold, it should be noted that the lower plane of the end plate and partition must be tightly pressed against the upper plane of the base, and should not be scratched. If necessary, while compressing the model, gently tap the upper plane of each plate with a wooden hammer to make it tightly attached to the base.

2. Before each mold installation, a thin layer of machine oil should be applied to the surfaces of the other components that make up the mold cavity, and then the partition should be tightly pressed against the positioning pin to prevent the mold cavity from tilting.

3. After each demolding, it should be wiped clean immediatelyElastic modulus cast iron cylindrical test moldApply oil to the remaining material on the surface of each component to prevent rust.