Large band saw machine

Product Introduction

High quality design of hydraulic gantry band saw machine - the combination of skills and imagination, bringing customers the use effect
1. Automatic cutting with feeding mechanism and clamping action provides precise cutting cycle.
2. A good saw belt tension and guidance system to maintain stable linear movement of the saw belt.
3. Regardless of the cross-section of the workpiece, hydraulic control can maintain stable cutting feed.
4. The device of quick contact rod can quickly lower the saw belt to the cutting position.
5. The entire cutting process is suitable for using an upper pressure device, which can be paired with a front clamp to avoid cutting vibration.
6. Multiple cutting sections with different lengths up to 9 types can be set.

Product Features

Safety Design - Each band saw machine of Magnesium Jia Machinery has the following characteristics:
Safety and thermal overload switch
Saw belt and saw wheel safety protection cover
After cutting, the saw belt automatically stops
Low voltage and zero voltage control
Saw belt breakage detection
As shown in the figure, there are two different systems. Please ask for detailed information to meet your needs
1. Standard cutting feed system
2. The amplification valve automatically adjusts the cutting feed rate to achieve the cutting effect
Accurate cutting length setting:
A sizing code table that is easy to read up to 0.1 mm or 0.01 inch decimal point, allowing for precise setting of the required cutting length.
Automatic lifting and rapid approach of saw belt: The quick touch rod mechanism can detect the size of the workpiece, allowing the saw belt to quickly descend and detach, saving a lot of time.
feed switch
The fast and slow feeding speed enables the workpiece to be accurately positioned at the set length position.
Passive wheel rotation detector:
This device can detect saw belt overload and breakage, and can automatically shut down.
Hydraulic saw belt tension control
The tension is automatically maintained during saw belt cutting; When turned off, the tension of the saw belt automatically relaxes, which can increase the lifespan of the saw belt.
Three point clamping of hydraulic actuator clamp:
The workpiece is clamped on both sides of the saw belt, and the operator can provide manual and automatic clamping modes through a simple button; This clamp clamping method allows for automatic cutting.
Independent feeding clamp:
The feeding bed seat is operated by clamps, which is different from the traditional mode of one fixed and one movable; It has a good clamping and feeding effect on warped materials, and can achieve the goal of precise cutting.