GSA Four Axis Repair Price

1TANSHINS Four Axis MaintenanceMaintenance:

Electric spindle maintenance manufacturers believe that even the best knives will become dull without frequent grinding, and even the best machines will malfunction without regular maintenance. Electric spindles also require daily maintenance.

(1) After finishing work every day, the operator should use a vacuum cleaner to clean the debris on the rotor end of the electric spindle and the motor wiring terminals to prevent debris from accumulating on the rotor end and wiring terminals, thereby avoiding debris from entering the bearings, accelerating the wear of high-speed bearings, and preventing debris from entering the wiring terminals, causing the motor to short-circuit and burn out.

(2) Every time the tool is changed for the electric spindle, the operator must unscrew the pressure cap clamp. The electric spindle cannot be changed by directly inserting or removing the tool. The operator should develop a habit of cleaning the clamp and pressure cap after unloading the tool.

(3) After starting up every day, the operator must check the working status of the cooling water flow of the electric spindle, check whether the water pump is working properly, check whether the cooling water is contaminated by scale and microorganisms, check whether the pipeline status is normal, and ensure that the cooling water circulates normally. It is strictly prohibited to turn on the electric spindle without cooling water passing through it. Only under the premise of normal cooling can the electric spindle be in good working condition. If the water pipe has a dead bend causing poor water flow or blockage of the pipeline by dirt, it will cause the electric spindle to fail to work normally and affect the processing effect.

IITANSHINS Four Axis MaintenanceInstallation:

1. Clean and corrode all components.

2. When necessary, the installed components need to be polished.

3. Clean the stator thoroughly, and replace it with a new one if the resistance is unstable.

4. Maintain concentricity and perpendicularity during component installation.

5. Correct installation of the rotor and dynamic balance correction of the rotor.

6. Install a new O-ring seal.

7. The distance ring of the bearing must be installed correctly between the bearings.

8. Use brand new bearings for installation, and immediately install the spindle motor after the bearings are unsealed. Otherwise, over time, the bearings will be contaminated with dust, leading to the failure of bearing grease.

9. Tool fixing device.

10. Adjustment of cone surface precision polishing.

11. Check for air leakage in the air pressure detection of the cooling system.

12. The spindle motor housing should be kept smooth.

13. Overall dynamic balance correction of spindle motor.