Unclean picking problem
1. The picking device is set too high, and the adjustment height is generally 5.08cm above the ground for the picking teeth
2. The pickup drive wheel is set too low, adjust the appropriate position according to the geographical environment.
3. If the picking teeth are bent or damaged, replace them with new ones.
4. The work speed is too fast, resulting in picking up litter.
5. If the straw in the field is sparse or exceeds the width of the picker, measures should be taken to pile up the straw.
6. Damaged cam drive or spring toothed bearings, replace with new bearings.
Abnormal noise issue with picking up structures
1. Elastic tooth deformation, correction or replacement of elastic tooth
2. The drum is broken, replace the drum
3. Wrap hay or hemp thread, take out the wrapped thing
4. Broken crank arm rolling bearing, replace crank arm rolling bearing
5. The grass ring is deformed or broken, replace the grass ring
The problem of the safety bolt of the baler flywheel being cut off
1. The bale density is adjusted too high, reduce the bale density and adjust the tension of the spring.
2. The gap between the moving and fixed cutting blades is too large. Adjust the gap between the cutting blades.
3. The plunger safety stopper is misaligned. Check and adjust the plunger safety stop device.
4. Check and adjust the timing of the feeding fork and plunger at irregular intervals.
5. During the knotting process, if the knotter clutch suddenly disengages (due to the clutch claw not rotating flexibly, collision block wear, roller bracket spring failure, roller wear), clean the clutch claw pin shaft with gasoline or kerosene and add lubricating oil; Replace faulty parts.
6. The blade of the grass cutting blade is not sharp, sharpening blade.
7. There are foreign objects in the material, remove them.
8. The spring pressure of the friction clutch is too high, adjust the spring pressure again.
9. The pressure of the brake spring of the bundling mechanism is too low. Adjust the pressure of the brake spring of the bundling mechanism.
10. Grass cutting blades collide, readjust blade clearance.
The problem of grass blockage in the picker and the inability of the bales in the drum chamber to rotate
1. Initial RPM too low, high throttle, low driving speed
2. Driving too fast,
3. The straw is too thick, and the height of the picker above the ground is too low. Adjust the height of the picker above the ground to make the grass fence more than 2 centimeters higher than the straw
4. The humidity of straw is too high, and the humidity of sun dried straw should not exceed 25%
5. The picker tilts too much, adjust the handwheel on the tow bar.