How much does a constant temperature and humidity chamber cost

250RH constant temperature and humidity chamberProduct Introduction:

Constant temperature and humidity incubatorIt has the function of bidirectional temperature regulation system for cooling and heating, and controllable temperature and humidity. It is a laboratory equipment for research and teaching departments such as plants, biology, microbiology, genetics, viruses, BOD detection, medicine, environmental protection, etc. It is widely used in constant temperature experiments, cultivation experiments, environmental experiments, etc. Its main features: This product adoptsNew intelligent temperature controllerTemperature/humidity control, LED digital display, intuitive and clear; Adopting a stainless steel inner liner, it has the advantages of being sturdy and highly corrosion-resistant.

250RH constant temperature and humidity chamberTechnical Indicators:

1. Power supply: 220V 50HZ
2. Refrigeration power: 150W
3. Heating power: 150W × 2
4. Temperature control range: 5-50 ℃ (digital display LED, with observation window)
5. Temperature control accuracy: ± 0.5 ℃
6. Humidity range: 50% -95%
7. Effective volume: 250L
8. Working hours: continuous

250RHInstructions for Use:

1. The incubator should be placed in a dry, clean, well ventilated studio away from heat sources and sunlight, and placed steadily to prevent vibration and noise.
Before use, all control switches on the panel are in a non working state.
3. Place experimental samples on the incubator rack, and maintain an appropriate distance between each experimental bottle (or vessel) to facilitate the circulation of cold (hot) air convection.
4. Connect the power supply and place the power switch in the "ON" position. The indicator light will turn on, and the LED digital display will show the actual temperature inside the box.
5. Then, based onIntelligent Temperature ControllerFollow the instructions to operate, set the temperature and humidity values you need, and the temperature controller will automatically control the temperature and humidity inside the box to remain constant (when the temperature inside the box is higher than the set value, the incubator will automatically cool down, otherwise the incubator will automatically heat up; the humidifier will automatically humidify).

250RHMaintenance and Warranty:

1. The incubator should be reliably grounded.
To ensure effective heat dissipation during condensation, the distance between the condenser and the wall should be greater than 100mm. There should be a 50mm gap on the side of the box, and at least 30mm space at the top of the box.
3. When handling, repairing, and maintaining the incubator, violent collisions should be avoided, and the maximum inclination should be less than 45 degrees.
After unplugging the power socket, insert it again after 5 minutes. If inserted immediately, the compressor components are prone to damage.
5．250RHWhen cooling, it is not advisable to make the temperature difference between the box and the ambient temperature greater than 25 degrees.
6. It is strictly prohibited to put volatile chemical solvents, explosive gases and combustible gases in the incubator. Combustible sprays are not allowed near the incubator to avoid ignition by electric sparks.
To prevent pollution, try to avoid condensation of frost on the inner wall of the studio when using at low temperatures.
When the refrigeration system is working, frequent opening of the door should be avoided, which is beneficial for maintaining temperature stability and preventing dust and dirt from entering. After the refrigeration system stops working, clean the working chamber with a soft cloth.