Sunflower seed hulling unitThe hulling is very clean, with high productivity. For hullers with selected equipment, high cleanliness, low loss rate, small breakage rate, high economic benefits, simple structure, reliable use, easy adjustment, and low power consumption are required. If the motor wants to work normally, the voltage needs to reach its rated voltage. However, farmers are located in scattered areas, and the wires and circuits used are not very standard, resulting in insufficient voltage in places far away from the transformer. Insufficient voltage affects the hulling rate and can easily shorten the equipment life. Before use, it is necessary to check whether all fasteners are tightened, whether the rotating parts are flexible, and whether there is lubricating grease in each bearing,Sunflower seed hulling unitIs it placed on a stable ground? Before use, check that the power voltage switch is in the off position.

　　

Sunflower seed hulling unitAfter the electric motor is started, the direction of rotation of the rotor should be consistent with the direction indicated on the implement. First, idle for a few minutes and observe for any abnormal noise. Only when the operation is confirmed to be normal, can the material be loaded for production. When the sunflower kernels contain more skin, the inlet air volume of the cyclone can be adjusted to increase the suction air volume, in order to achieve the goal of completely absorbing the skin. When the content of un detached grains in the kernel exceeds the standard, the angle between the vibration motor and the sieve surface should be adjusted in a timely manner to improve the selection effect. During production, people should stay away from the vibration motor to avoid injury.Sunflower seed hulling unitThe requirements for sunflower seeds are that they are suitable for both dry and wet conditions. If they are too dry, the breakage rate will be high, and if they are too wet, it will affect work efficiency. Sunflower seeds stored in rural areas are generally relatively dry. To make them suitable for dryness and wetness, the following methods can be used: immediately remove them after soaking and cover them with plastic film for about 1 day, then air dry them in the sun until they are suitable for dryness and wetness before starting to shell them.